MESURES DE PRÉCAUTION
TROUBLESHOOTING
Important: Si les conduits d’air dans l’unité, le tuyau ou le tube d’extension bloquent, éteignez l’aspirateur et enlevez la substance qui bloque avant de remettre en marche l’unité .
1. | N’utilisez pas l’aspirateur trop près | 5. | Lorsque vous tirez la fiche | |
| des chaufferettes ou des |
| électrique de la prise murale, tirez | |
| radiateurs. |
| la fiche et non le cordon | |
2. | Avant d’insérer la fiche électrique |
| d’alimentation. | |
6. | Ne pas se servir de l’appareil pour | |||
| dans la prise murale, | |||
| d’avoir les mains sèches. |
| ramasser quelque chose qui brûle | |
3. | Ne nettoyez rien de liquide avec |
| ou qui fume comme des cigarettes, | |
| des allumettes ou de la cendre | |||
| l’aspirateur. |
| ||
|
| encore chaude. | ||
4. | Éloignez les cheveux, les |
| ||
7. | Ne PAS passer l’aspirateur sur le | |||
| vêtements amples, les doigts, les | |||
|
| cordon d’alimentation. | ||
| pieds et toute partie du corps des |
| ||
| 8. | Ne pas utiliser sans le bac à | ||
| ouvertures, du rouleau des |
Changing the Headlight WARNING: To reduce the risk of electric shock, the power cord must be disconnected before performing maintenance/trouble shooting checks. Occasionally the headlight will require changing.
1.Turn the vacuum off and unplug from the electrical outlet.
2.With a flathead screw driver, insert the end of the screwdriver into the two slots on top of the headlight lens and gently pull down. (Fig. 60)
Lens Slots
Fig. 60
3.Lift out the headlight lens.
4.Remove the light bulb by pulling it out carefully.
5.Replace the new bulb by pushing it in.
6.To replace the headlight lens, insert the bottom tabs of the lens into the holding slots and snap the top back into place to secure.
brosses rotatives et de toutes | poussière, le collecteur cyclone ou |
autres pièces mobiles. | TOUS les filtres en place. |
| 9. Avant de commencer à passer |
| l’aspirateur, |
| les gros objets ou les objets pointus |
| qui pourraient endommager |
| l’aspirateur. |
34
PROBLEM SOLVING
This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem occurs, it usually can be solved quite easily when the cause is found. Therefore, this checklist is provided for your convenience.
PROBLEM |
| POSSIBLE CAUSE | POSSIBLE SOLUTION | ||
|
|
|
|
| |
| 1. | Not properly plugged into wall | 1. | Plug in firmly. | |
Cleaner Won’t |
| outlet. | 2. | Reset circuit breaker or | |
2. | No electricity in wall outlet. |
| replace fuse. | ||
Run |
| ||||
3. | On/Off switch not turned on. | 3. | Push on/off switch to on | ||
| |||||
| 4. | Motor thermostat tripped. | 4. | Reset motor thermostat. | |
|
|
|
|
| |
| 1. | Full or clogged dust cup. | 1. | Clean dust cup. | |
| 2. | Wrong carpet height setting. | |||
| 2. | Adjust setting. | |||
| 3. | Clogged air path. | |||
| 3. | Remove obstruction. | |||
| 4. | Clogged hose. | |||
Cleaner Won't | 4. | Remove obstruction. | |||
5. | Broken belt(s). | ||||
5. | Replace belt(s). | ||||
Pick Up | 6. Telescopic wand not inserted | ||||
6. | Push telescopic wand in | ||||
|
| fully. | |||
|
|
| securely. | ||
| 7. | Dirty filters. |
| ||
| 7. | Clean / change filters | |||
| 8. | Debris screen needs | |||
| 8. | Clean debris screen. | |||
|
| cleaning. | |||
|
|
|
| ||
Cleaner Picks |
|
|
|
| |
Up Moveable | 1. | Wrong carpet height setting. | 1. | Adjust setting. | |
Rugs Or Pushes | |||||
|
|
|
| ||
Too Hard |
|
|
|
| |
|
|
|
|
| |
Agitator Does | 1. | Broken belt(s). | 1. | Replace belt(s). | |
Not Turn | 2. | Belt(s) installed incorrectly. | 2. | Check belt changing. | |
|
|
|
|
| |
Air Flow | 1. | Attachment use restricts air |
|
| |
Restricted With |
| flow. | 1. | Check attachment. | |
Attachment Use | 2. | New carpet debris clogging | 2. | Remove obstruction. | |
Sound Changes |
| air path. |
|
| |
|
|
|
|
| |
|
| 15 |
|
|