AT&T TL7700 user manual FCC Part

Page 37

Appendix

FCC Part 15

This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 15 of the Federal Communications Commission (FCC) rules.

These requirements are intended to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Privacy of communications may not be ensured when using this device.

To ensure safety of users, the FCC has established criteria for the amount of radio frequency energy that can be safely absorbed by a user or bystander according to the intended usage of the product. This product has been tested and found to comply with the FCC criteria. The headset may be safely held against the ear of the user. The telephone base shall be installed and used such that parts of the user’s body other than the hands are maintained at a distance of approximately 20 cm (8 inches) or more.

This Class B digital apparatus complies with Canadian ICES-003.

33

Image 37
Contents User’s manual Congratulations Parts checklist Table of contents Headset lights Quick reference guide headsetVOL+/VOL Headset alert tones Quick reference guide headset charger Avoid placing the telephone base too close to InstallationBattery installation Battery charging and connecting charger power Add and register headsets Register a headset to an AT&T Dect cordless telephone base Replace a headset You may need to deregister your headsets ifEarbud Headset attachmentsTo remove the earbud from the headset earpiece To attach the earbud to the headset earpieceOver-the-ear hook To adjust the headset to wear on the left or right earTo attach the ear hook to the headset To remove the ear hook from the headset Over-the-head band To attach the head band to the headset To remove the head band from the headset Behind-the-neck band To attach the neck band to the headset To remove the neck band from the headset My headset doesn’t work at all TroubleshootingOther party cannot hear my voice during a call There is no dial toneCannot dial out Battery does not chargeMy cordless headset isn’t performing normally Troubleshooting Troubleshooting My calls cut in and out while I’m using my cordless headset Hear other calls while using my headsetWant to use my headset with a different telephone base Light on the headset is off while charging Cannot register the headsetCommon cure for electronic equipment Important safety information Important safety information Important safety information Pacemaker patients Precautions for users of implanted cardiac pacemakersCleaning your headset MaintenanceTaking care of your headset Avoid waterFCC Part 68 and Acta Industry Canada FCC Part What does this limited warranty cover? Limited warrantyHow long is the limited warranty period? How do you get warranty service? Other limitations Dect 6.0 digital technology Technical specifications