Euro-Pro EP238 manual Using the Vacuum Cleaner

Using the Vacuum Cleaner

•Before starting the vacuum for the first time, check that the dust bag (17) and the filters (8 & 11) are properly set in place.

Note: A safety catch on the dust bag support (2) prevents the cover from being closed if the dust bag (17) is not in place.

Make sure that the dust bag (17) is properly inserted and the cover is closed before using the vacuum.

•To open the bag compartment cover (1),put your hand under the cover (1) and lift up. (See fig. 1)

•To close the bag compartment cover (1), press downward on the cover with your hand on top of the cover (1), until you hear a click.

•Fit the flexible hose (12) into the cleaner hose coupling hole (3) and turn it right until it is secured in its place. (See fig. 2)

•The accessories fit directly on the tube handle (10) or may be used with the extension tubes (14) to reach further away.

•Attach the deluxe turbo brush floor attachment (23) to the end of the telescopic tube (14). (See fig. 3)

•Now you may plug the vacuum into the wall outlet. To do this, pull out as much of the power cord as you need. Start the vacuum cleaner by pushing on the on/off button (6). (See fig. 4)

•When you are finished vacuuming, switch the vacuum cleaner off by pushing the on/off button (6). (See fig. 4)

•Unplug the vacuum and rewind the cable by pushing the cord rewind button (5) (See fig. 5) Hold the plug when rewinding the cord. Do not allow the cord to whip when rewinding. If the cord does not fully retract, pull it out again and then press on the cord rewind button (5) again.

•The suction regulator (19) shown in Fig. 6 allows you to regulate the amount of suction obtained from the vacuum cleaner.

Fig. 1

Fig. 2 Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6