B |
C |
Turn cleaner over. Remove HOOVER® emblem (B). Using a Phillips screwdriv- er, remove the screw (C), located under- neath the emblem.
A |
Replace hood - Reposition hood, fit- ting tabs (A) on either side under the lens cover as shown. Replace screw and HOOVER® emblem. Turn cleaner over and replace the two screws located on the bottom of the cleaner as shown in Fig.
B |
Pull up on agitator (B) to remove from agitator cavity.
Using a flat screwdriver, pry off hood as shown and remove.
The agitator brush roll
When to replace
When agitator brushes are worn, the agitator should be replaced.
To check condition of brushes, discon- nect cleaner from electrical outlet. Move edge of a card across bottom plate while turning agitator. To maintain cleaning effectiveness, have brush roll replaced if brushes do not touch card.
What to buy
When purchasing a new agitator, ask for
HOOVER part No. 48414137.
c |
B |
Holding agitator (B) with one hand, slide belt (C) off the agitator.
Discard old agitator.
Install bulb - Pull old bulb straight out of socket. Push new bulb straight into socket until locked in place
Excessive force is not required.
A |
How to replace
Disconnect cleaner from electrical outlet.
To remove bottom plate, step on handle release pedal and place cleaner in the lowest position. Turn cleaner over. Using a Phillips screwdriver, remove the seven screws and lift off the bottom plate (A).
C |
D |
Note: Do not allow belt (C) to fall back into cavity (D) on bottom of cleaner.
Continued ➜ | 9 |