2 - 7 | 2 - 8 | 2 - 9 |
|
|
|
F
E
Hard surface floor cleaning
The power nozzle can be used for cleaning hard surface floors such as wood, linoleum, vinyl, asphalt and rub- ber tile, sealed cork, concrete and ter- razzo, as well as carpet.
To set the power nozzle for hard surface floor cleaning, push the floor surface selector button toward “BARE” (E). This setting provides suction and no agitator action. If you prefer, you may use the hard floor tool to clean bare floors.
You will find it particularly convenient when cleaning lightweight area rugs to set the floor surface selector button on “BARE” and continue cleaning the sur- rounding floor surfaces.
Note: The headlight will be ON in both the “RUG” and “BARE” floor surface modes.
Edge cleaning
Special edge groomers are provided on both sides of the nozzle to remove dirt in carpet near baseboards and furniture.
Guide side of nozzle parallel to edge of carpet or furn i t u re as shown.
Variable speed control
The variable speed control (F) is located on the hand grip.
Slide the control back to reduce energ y consumption and to clean lightly soiled
a reas or delicate fabrics. Slide control for- w a rd for maximum cleaning power in heavily soiled areas. If the power nozzle is d i fficult to push, slide the control toward back to reduce the pow e r. This will help p r event damage to the belt.
Cleaning tools
The cleaning tools are conveniently stored in the cleaner underneath the tool lid. Pull up on edge of lid in recessed area to open.
The lid is also designed with a “break- away” feature which allows it to snap off if it is pushed open too far. To
The cleaning tools have many uses. Select the tool best suited for the clean- ing task from the following descriptions.
2 - 10 H
L
IJ
K
Select the proper tool
H. Crevice tool may be used in tight spaces, corners, and along edges in such places as dresser drawers, uphol- stered furniture, stairs and baseboards.
I. Furniture nozzle may be used for upholstered furniture, draperies, tapes- tries, mattresses and clothing.
J. Dusting brush may be used for carved furniture, table tops, books, lamps, lighting fixtures, venetian blinds, baseboards, shutters and registers.
K. Hard floor tool may be used for walls and very irregular hard surface floors such as brick and slate.
L. Powered hand tool may be used for upholstered furniture, carpeted stairs, and hard to reach places.
2 - 11
How to connect
To use the cleaner with tools, disconnect the power nozzle from the hand grip.
Tools may be attached directly to the hand grip. With the latch in the unlock 
position, insert tool (or wand if extra length is needed), then push latch to the lock 
position to secure.
To remove the tool (or wand), push the latch to the unlock 
position.
To connect tools to metal wands, insert end of tool into wand and snap into position. To disconnect, press down on the center of spring latch and remove tool.
6