3 - 73 - 8
The micro filter aids in the filtration | If filter is dirty, open grid on cassette |
process to return clean air to the room. | and remove filter. Wash filter in warm |
To remove this filter, open tool lid, | water or replace it with a new one. A |
remove dusting brush and pull up red fil- | dry filter must be put back into cleaner. |
ter cassette. |
|
Power Nozzle belt replacement
The belt in your power nozzle drives the a g i t a t o r. It has been designed specifi- cally for use in this cleaner and is impor- tant for effective operation.
What to buy
T h e re are other belts manufactured that a re similar in shape and size, but are not designed for the HOOVER power nozzle. Such belts do not operate the agitator
c o rrectly and may create stress which could damage your power nozzle. Use only a genuine HOOVER Belt p a rt n o .
4 0 2 0 1 1 8 0 when a belt replacement is n e c e s s a ry.
When to replace
The belt should be checked from time to time to be sure it is in good condition. To check, remove the hood (see following section). Replace the belt if it is stre t c h e d , cut, or broken.
3 - 9
How to replace
Disconnect cleaner from electrical outlet and disconnect power nozzle from extension wands.
To remove hood, turn nozzle over and
3 - 10
Return nozzle to original position and lift off hood.
unscrew the 4 recessed Phillips head screws.
Note: Do not remove the 3 screws in the triangle formation as these hold the motor in place.
3 - 113 - 12
CC
3 - 13
D
Remove brush roll cover (C) by remov- ing the 3 Phillips head screws.
Lift off brush roll cover (C).
If belt is not broken but is stretched or cut, pull it off the motor pulley (D).
Continued ➟ 9