How to replace agitator belt
Disconnect cleaner from electrical outlet.
Place cleaner on the floor. For ease in installation, follow the direc- tions given below, positioning yourself to the left, rear of the cleaner.
AGITATOR END PLATE
7.Grasp agitator firmly (be sure you can see agitator end plate.) and guide end opposite belt into position.
8.Roll other side of agitator into place.
CLIPS
1.Turn cleaner over. Release handle to lowest position. Remove plate on bottom of cleaner by releasing clips. (See illustration.)
3.Lift out agitator and remove old belt.
MOTOR
PULLEY
BELT
2. Then lift off bottom plate.
END PLATES |
4.If the end plates have loosened, tighten them by turning in opposite directions.
9.Press firmly to be sure agitator is secure. Turn agitator to ensure proper belt placement.
10.The bottom plate attaches in a
5. Place new belt over metal |
|
motor pulley, with lettering on | 6. Slip plastic pulley end of |
belt visible and not against | agitator through belt. (See |
pulleys. | illustration.) |
11.Maintaining front connec- tion, rotate bottom plate to cover bottom of cleaner. Press firmly.
12.Lift and snap retaining clips into place.
19 |
20