The headlight
What to buy
This cleaner uses a 12 volt, wedge base bulb.
Hoover part No. 27313101
How to replace
Disconnect cleaner from electrical outlet.
1. Place screwdriver into one of |
the slots at lower edge of lens. |
Press handle of screwdriver |
SELF
PROPEL
BELT
AGITATOR
BELT
What to buy
The belts
There are two belts on your cleaner. One belt drives the agitator; the other operates the Self Propel feature.
When buying new belts, you should always insist on genuine HOOVER parts. Other belts may not meet the Hoover design and quality control standards. They may not operate the agitator or Self Propel transmission correctly and may cause damage.
down to release lens. Repeat |
in second slot if necessary. |
2. Lift out lens. |
➘
3. Pull old bulb straight out of |
socket. Push new bulb straight |
into socket until locked in place. |
Excessive force is not re- |
Agitator belt - Hoover part No. 38528008
Self Propel belt - Hoover part No. 160147
Agitator belt
When to replace
Check from time to time to be sure the belt is in good condition. If it is stretched, cut, or broken, it should be replaced.
quired. |
4. Replace lens by inserting | ➘ |
tabs on top of lens under edge | ➘ |
of opening on cleaner. | |
5. Press firmly at bottom of lens | ➘ |
to snap lens into place. |
|
|
|
NOT BROKEN
BROKEN
The “BELT CHECK” indicator (some models only) will spin when the cleaner is turned on and the agitator belt is not broken.
If the indicator does not spin and the orange bar is visible when the cleaner is turned on, the belt is broken and must be replaced.
The cleaner must be turned on for the indicator to register a broken belt.
The “BELT CHECK” indicator does not register a broken Self Propel belt.
Continued ➜
17 | 18 |