Lubrication
The motor is equipped with bearings which contain sufficient lubrication for the liie of the motor. The addition of lubricant could cause damage. Do not add lubricant to motor bearings.
The agitator is equipped with two ball bearings that should be lubricated periodically by a Hoover Factory Service Center or an Authorized Hoover Warranty Service Dealer (Depot).
If you have a problem
This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem occurs, it usually can be solved quite easily when the cause is found. Therefore, this check list is provided for your convenience.
| Problem |
| Possible cause | Possible solution |
| Cleaner | I. | Not ftrmly plugged in. | I. Plug unit in firmly. |
won’t | 2. No voltage In wall plug. | 2. Check fuse or breaker. | ||
| run | 3. | lbWwlfl~seArlpped | 3. Replace fuse/reset |
|
|
| . | breaker. |
|
|
|
| |
| Cleaner | I. Broken or worn belt. | I. Replace belt. | |
| won’t | 2. Agitator brush roll | 2. Replace brush roll. | |
| pick up |
| worn. |
|
|
| 3. Bag full. | 3. Change paper bag. | |
|
| 4. Incorrect carpet height | 4. Move nonle control | |
|
|
| setting. | knob to type of carpet |
|
| 5. Hose end notsecure In | being cleaned. | |
|
| 5. Push hose end firmly | ||
|
|
| tool rack | into %up” In tool rack= |
|
|
|
| |
| Cleaning | I. Hose clogged | I. Remove hose and tools; | |
| tools won’t |
|
| remove obstructlon. |
| pick up | 2. Incorrect setting. | 2. Move knob to “Cleaning | |
|
|
|
| Tools”. |
|
|
|
| |
| Cleaner | I. Incorrect carpet height | I. Move nozzle control | |
| hard |
| setting. | knob to a higher setting. |
| to push |
|
|
|
|
|
|
|
|
26