tNOZZLE
Carpet height adjustment
The cleaning of carpet and rugs takes place at the nozzle.
|
|
|
| If it is necessary to raise and lower | |
’ | I | NOZZLE CONTROL |
| the nozzle for various carpet pile | |
| heights, slide the nozzle control | ||||
KNOB | I | ||||
knob to the correct setting. | |||||
|
| ||||
|
|
|
| For ease in sliding knob, the handle | |
|
|
|
| should be in the upright position. | |
|
|
|
| The nozzle will not move into the | |
|
|
|
| adjusted position until the cleaner | |
|
|
|
| handle is lowered to the operating | |
|
|
|
| position. | |
|
|
|
|
When using hose and tools, slide knob to the Cleaning Tools setting. Return knob to the correct setting when cleaning floors. Do not leave knob in Cleaning Tools setting when cleaning floors.
Leave hose attached to cleaner and place other end firmly into tool rack for peak performance when cleaning carpets.
For maximum cleaning performance the following carpet height settings are recommended.
•Setting 1: for low pile, level loop, kitchen type carpet.
•Setting 2: for other types of carpet.
•Higher Settings:* for very deep pile carpet where easier pushing effort is desired, while maintaining good cleaning performance.
•Setting 5: for hose and cleaning tool use only.
*Note: If the cleaner is difficult to push, slide the knob to the next higher |
|
setting. | 14 |
|