Step 3 Attach cloth outer bag
7
C
M 
L 
Note location of tapered rails (L) on back of outer bag base (M) and on front of lower handle (C).
8 |
|
M | N |
| |
| C |
Slide rails on outer bag (M) onto rails on lower handle (C) until outer bag base snaps past the lock tab
(N).
9
M
O
N
The hole (O) in the handle is visible through the
Be sure that power cord is pulled tight and pressed into each of the three notches (Fig. 6) before com- pleting the following steps.
10
P
Q
M
R
Note round opening (P) and hooks
(Q) on back of outer bag (M).
Place opening over dirt tube (R). Unzip outer bag and place hand inside. Press down firmly to snap hooks into handle.
Step 4 Attach handle
11 |
S |
With outer bag to the front, place assembled handle onto handle base
(S) of cleaner body.
Rock handle side to side while pushing down firmly. Extra push- ing effort may be required.
12 |
T |
NUT |
Press the handle release lever to move handle to the operating or middle position.
Push bolt (T) into hole on lower front of handle.
If bolt will not go through hole easily, handle is not pushed com- pletely down.
13 |
U |
NUT |
Place nut in recessed area (U) at back of handle. Hold nut in place while tightening bolt securely with a screw driver.
Note: Only one nut is needed on this model. The extra nut is not required but has been provided for your convenience.
Note: Do not hook bag clip to retain- er. This will be done in a later step.
Step 5 Attach filter bag
14
R
V
V 
Hold filter bag collar (V) as shown. Align opening in filter bag with dirt tube (R) inside the outer bag.
Push bag collar firmly onto dirt tube. Tuck in filter bag; zip outer bag.
15
E
F
Break off red tab (E) above ON/OFF switch (F) by pushing down on tab. Discard tab.
Note: If tab has come off during assembly, make sure switch is in the OFF position (down) before plugging cord into an electrical outlet.
4