Briggs & Stratton 5621, 5631 manual HPV Control Levers, Use of Lifting Lug, Starting Instructions

Page 10

C. Use of Lifting Lug

Little Wonder High Performance Vac is supplied with convenient Lifting Lug that can be used when you need to move or tie down the unit.

WARNING DANGER

DO NOT USE OR SERVICE THE UNIT WHEN IT’S

SUSPENDED FROM THE LIFTING LUG.

Operation

WARNING DANGER

THE OPERATOR OF THIS HIGH PERFORMANCE

VAC IS RESPONSIBLE FOR ACCIDENTS OR HAZARDS OCCURRING TO HIMSELF, OTHER PEOPLE OR THEIR PROPERTY.

A. Starting Instructions

WARNING DANGER

FUEL IS EXTREMELY FLAMMABLE. HANDLE IT

WITH CARE. KEEP AWAY FROM IGNITION SOURCES. DO NOT SMOKE WHILE FUELING YOUR EQUIPMENT.

1.Perform pre-starting checks (engine oil and gas level, all safety inspections, etc. Read entire Owners’ Manual for all pre-starting information.)

2.Release the Transaxle Engagement Lever

3.Make sure Gas Supply Knob (located above Recoil Starter) is turned to On position.

4.Move Choke Lever (located above and to the left of the Recoil Starter) to Choke position.

5.Move Throttle Control Lever (located on Left Handlebar) to Middle Position or Full Position (toward Rabbit symbol.)

6.Pull Recoil Starter Handle slowly until resistance is felt, then pull firmly to start engine.

7.When engine starts, slowly move Choke Lever to Open position.

8.Increase Throttle Control Lever to Full Speed if desired.

9.NOTE: If engine is difficult to start: Press Belt Tension Lever down with your left foot before pulling Recoil Starter Handle. (This disengages the belt for easier starting.) When engine starts, slowly release your foot from the Belt Tension Lever.

B. Self-Propelled Instructions

1.With engine running (and Transaxle Lever in Engage position) slowly press Bail Handle downward to self- propel vacuum FORWARD. The farther down you press the Bail Handle, the faster the speed of the vacuum. Slowly release the Bail Handle to reduce speed or to stop.

2.To self-propel in Reverse, first press downward on the Reverse Lever, and (with the Reverse Lever pressed down) press downward on the Bail Handle. The farther down you press the Bail Handle, the faster the speed of the vacuum in REVERSE. Slowly release the Bail Handle to reduce speed or to stop.

3.Releasing the Bail Handle at any time stops the vacuum from movement.

HPV Control Levers

RECOIL STARTER HANDLE

NOZZLE CONTROL

KNOB

BELT TENSION LEVER Step on to release belt tension when starting

REVERSE LEVER Press to engage

reverse mode

THROTTLE CONTROL LEVER

GAS SUPPLY KNOB

CHOKE LEVER

BAIL HANDLE Press to propell

HPV forward or reverse

BAND CLAMP

CLASP

TRANSAXLE ENGAGEMET LEVER

Pull and latch to disengage

Release to engage

WARNING DANGER

ENGINE EMITS CARBON MONOXIDE. DO NOT OPERATE OR REFUEL IN ENCLOSED AREA.

9.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Self Propelled General Safety Rules Table of Contents Important InformationSafety and Warnings Assembly InstructionsSafety Decals UnpackingSafety and Warnings Do not Smoke When Filling Fuel Tank Engine/ Fuel Warnings Don’ts Engine/ Fuel Warnings Do’sBand clamp behind the bracket overlap Seal strap AssemblyAttach nozzle assembly to base unit Bridge clampPage Put Oil and Gasoline in Engine Before Starting Starting Instructions HPV Control LeversUse of Lifting Lug Self-Propelled InstructionsEmpty Debris Bag VacuumingRefueling the Engine Storage MaintenanceArea Every After First Use Hrs Hrs of Use Hours Removing Blockage in Moving Parts Directions for removing the Fan and reinstallationChanging V-Belt HPV Parts Assembly HPV Parts List Belt GuardHPV Engine Assembly HPV Deck AssemblyHPV Collector Assembly Swivel Assembly 3/8-24HPV Liner Assembly HPV Nozzle AssemblyLittle Wonder Phone 877-596-6337 FAX
Top Page Image Contents