17 Check
Is there continuity?
No: Repair or replace the connectors or wiring from
Yes: Continue.
18 Check
Is there continuity?
No: Repair or replace the connectors or wiring from
Yes: Continue.
19 Check
Is there continuity?
No: Repair or replace the connectors or wiring from
Yes: Continue.
20 Reconnect J/P40, J/P53, and J/P55.
•Run diagnostic test 008.
Is error code 083 displayed?
No: Continue.
Yes: Verify again that J/P40, J/P53, J/P55, and J/P54 are connected properly. If they’re not, connect them properly, then turn to TAG 002: Check & Problem Resolution. If they are, replace the PCL board, then turn to TAG 002: Check & Problem Resolution.
21 Interchange P53 and P55.
•Run diagnostic test 008.
Does the error code change from 081 to 082?
No: Continue.
Yes: Adjust the tray front sensor position. If this resolves the problem, turn to TAG 002: Check & Problem Resolution. If this does not resolve the problem, replace the tray front sensor, then turn to TAG 002: Check & Problem Resolution.
22 Does the error code change from 082 to 081?
No: Replace the job offset assembly, then turn to TAG 002: Check & Problem Resolution.
Yes: Adjust the tray rear sensor position. If this resolves the problem, turn to TAG 002: Check
&Problem Resolution. If this does not resolve the problem, replace the tray rear sensor or job offset sensor, then turn to TAG 002: Check & Problem Resolution.
Troubleshooting Analysis Guide (TAGs) |