To remove the duplex skew correction cable:
1Open the top cover.
2Remove the duplex tray.
3Remove the paper guide from inside the duplex tray (four screws).
4Slide the skew correction guides toward the center of the duplex tray.
5Remove the bracket holding the shaft in place (two screws).
6Remove the screw holding the cable mounting plate in place.
7Lift the skew correction guides and shaft up out of the duplex tray.
8Remove two screws holding each pulley assembly in place.
9Remove the spring from the cable.
10Lift the skew correction cable and pulley assemblies from the duplex tray.
Replacement Notes:
The placement of the mounting bead is critical. Set it on precisely. Replace parts in this order:
•First reinstall the pulley assembly.
•Then, wrap the cable three times around the drive gear pulley.
•Finally, connect the spring.
Removal/Replacement Procedures |