“B” Roller Removal“B” Roller Removal
To remove the “B” roller:
1Open the top cover.
2Remove the rear duplex cover. (See page
3Remove the upper duplex roller cover (four screws).
4Remove the lower duplex roller cover (four screws).
5Remove the front
6Remove two screws holding the duplex control board cover in place.
7Move the cover to the left out of the way.
8Loosen the screw holding the idler roller in place.
9Remove the duplex drive belt.
10Remove the drive gear (single
11Slide the “B” roller out from the back of the printer.
B Roller | Duplex Control |
Board Cover | |
Drive Gear |
|
Loosen Screw |
|
Duplex |
|
Drive Belt |
|
Side Detail
Upper Duplex
Roller Cover
Lower Duplex Roller Cover
Bearing
Removal/Replacement Procedures |