(004 intentionally excluded)
012Transfer Charger Test1Remove the photoconductor unit and place it in its protective packaging. Close the top cover.
2Go to: 012
3Press: READY to run the test. The transfer charger turns on and off repeatedly.
4Confirm that the display alternates between “0” and “1,” accompanied each time by a brief tone. The display indicates the following:
Table
DisplayIndication
0Transfer charger off
1Transfer charger on
These codes may indicate specific error conditions:
Table
DisplayIndication
041Seam sensor (sender) short
050Transfer charger short
051Transfer charger open or not installed
5Press: STOP to exit.
6Reinstall the photoconductor unit.
Diagnostic Tests |