TAG 800: Prints Blank or With Dark Horizontal Bands
Error Code: | 800 |
Possible Defects: Photoconductor unit,
Printhead assembly
IGS board
Main drive gear assembly
Connectors or wiring
Transfer charger
High voltage unit
Upper paper guide assembly
Developer unit
If there is a developed image on the paper other than dark horizontal bands, follow TAG
804: Prints With Light Horizontal Bands.
1Turn the printer off and unplug the power cord.
• Verify that J/P7, J/P27, J/P41, J/P23, J/P30, J/P31, and transfer charger high voltage unit lead are connected properly.
• Perform the
• Run test prints.
Has the problem been resolved? No: Continue.
Yes: Loose connectors or contamination were at fault. Turn to TAG 002: Check & Problem Resolution.
2Check the voltages, as outlined in Chapter 9, “General Printer Maintenance” .
Are the voltages correct?
No: Replace the high voltage power supply unit, then turn to TAG 002: Check & Problem Resolution.
Yes: Continue.
3Have the photoconductor unit, main charger, developer unit, and toner cartridge been replaced recently?
No: Continue.
Yes: Go to #6 in this TAG.
4Replace the photoconductor unit and main charger.
• Run test prints.
Has the problem been resolved?
No: Reinstall original photoconductor unit and main charger and continue.
Yes: The photoconductor unit was at fault. Turn to TAG 002: Check & Problem Resolution.
Troubleshooting Analysis Guide (TAGs) |