EP Cover Removal
6Remove the fuser drive cover (three screws).
7Remove the two supports for the vacuum transport unit (one screw each).
8Duplex only: Remove the duplex fan. (See page
9Remove the four screws holding the EP cover in place (two front and two back).
10Remove the upper right screw holding the fuser drive in place.
11Lift the EP cover straight up and out of the printer.
Replacement Note:
The higher of the two drive shaft support arms should be facing the left side of the printer.
Support Screw
Fuser Drive Screw
Fuser Drive Cover
EP Cover Screws
Back Detail
Removal/Replacement Procedures |