Exit Roller Assembly Removal
5Remove the fuser drive cover (three screws).
6Remove the exit pinch roller. (See page
7Duplex only: Remove the lower duplex drive (3 screws).
8Remove the back screw holding the exit guide in place.
9Tilt the exit guide toward the center of the printer.
10Remove the front
11Slide the exit roller out the back of the printer.
Note: Use caution so as not to damage the paper full or exit sensors.
Exit Guide
Fuser
Drive
Cover
Exit Pinch Roller Screw
Exit Guide Screw
Lower Duplex Drive (C30D only)
Back Detail
Removal/Replacement Procedures |