Main Motor Removal
8Remove the right side cover. (See page
9Remove the counter. (See page
10Remove the main drive cover (one screw).
11Remove the fuser drive cover (three screws).
12Remove the gear stay cover.
13Remove the gear stay (three screws).
14Remove the disk drive housing. (See page
15Remove the printhead. (See page
16Remove the DC power supply. (See page
17Remove the main motor gear and bearing (two
18Disconnect CN95.
19From the right side, remove the two screws holding the main motor in place.
20From the back, remove the three screws holding the main motor in place.
21Remove the main motor through the side of the printer.
Replacement Notes:
•
•
Remove the drive shaft key from the old motor. Replacement motors are not supplied with a key.
Be sure to tuck the CN95 connector under the motor after installation so that the wires do not protrude into the disk drive assembly area.
Main Motor Detail
Capacitor
CN95
Capacitor Contacts
Removal/Replacement Procedures |