HP C30 manual Paper Path

2The paper upon passing through the “B” roller comes in contact with the duplex sen- sor. (If the paper does not energize this sensor in a given amount of time, an error 060 will occur.)

3The “C” roller bidirectional motor turns on and passes the paper into the turnaround tray. The paper sensor in the turnaround tray is activated and the paper is center regis- tered. (If the paper does not energize this sensor in a given amount of time after leav- ing the duplex sensor, an error 061 will occur.)

4At this time the solenoid for the router at the turnaround tray engages so the paper can be routed to be printed on the duplex side.

5In a given amount of time after the paper energizes the paper sensor in the turnaround tray, the bi-directional motor reverses and passes the paper to the paper timing roller. (If the paper does not energize the paper timing sensor in a given amount of time after leaving the turnaround sensor, an error 062 will occur.)

6At this point, the same steps happen as during a simplex cycle.

Figure 1-2. Paper Path

1-6 Printer and Troubleshooting Overview