Photoconductor Rear Guide Rail Removal

Photoconductor Rear Guide Rail Removal

To remove the photoconductor rear guide rail:

1Open the front, back, and top covers.

2Remove the photoconductor and place in its protective packaging.

3Remove the developer unit.

4Remove the paper feed drive cover (three screws).

5Remove the photoconductor seam sensor. (See illustration on page 7-33.)

6Remove the spring at the base of the guide rail. To do this, gently pull the spring for- ward off its post.

7Disconnect CN64.

8Remove the ground screw.

9Remove CN64 from its bracket.

Ground Screw

CN64

Back Detail

Paper Feed Drive Cover

Removal/Replacement Procedures

7-35

Page 371
Image 371
HP C30 manual Photoconductor Rear Guide Rail Removal