HP C30 manual Assembly

Table 1-1. Error Code Technical Definitions (Continued)

Type	Error	Description
	081	PCL board activated the jogging motor but did not detect a change
		in the signal from the front sensor in the job offset assembly (diag-
		nostic test only).
	082	PCL board activated the jogging motor but did not detect a change
		in the signal from the rear sensor in the job offset assembly (diag-
		nostic test only).
	083	PCL board activated the jogging motor but did not detect a change
Errors		in the signal from either the front or rear sensors in the job offset
		assembly.
	084	PCL board detected a signal from the duplex control board #2 indi-
Jogger		cating that the registration side sensor did not activate after com-
		mand was sent to the duplex control board #2 to turn on the resist
		motor (diagnostic test only).
	085	PCL board detected a signal from the duplex control board #2 indi-
		cating that the registration side sensor did not deactivate after a
		command was sent to the duplex control board #2 to turn on the
		resist motor (diagnostic test only).
	086	PCL board detected a signal from the duplex control board #2 indi-
		cating that either the registration side sensor was activated and
		would not deactivate or was deactivated and would not activate
		after a command was sent to the duplex control board #2 to turn on
		the resist motor.
	090	PCL board detected that one of the cover interlocks was not acti-
Errors		vated (diagnostic test only).
	097	PCL board detected a signal from the IGS board indicating the
		absence of +12 Vdc.
LVPS	098	PCL board detected a signal from the IGS board indicating the
		absence of ‚-12 Vdc.
	099	PCL board detected a signal from the IGS board indicating the
		absence of +24 Vdc.
	100, 102	IGS board detected a failure of the PCL board status codes.
	101	PCL board detected that the IGS board was in a halt state (diag-
		nostic test only).
	121-127	PCL board detected an error in the communication between the
		PCL board and the IGS board.
Errors	130-134	PCL board detected an error during the internal diagnostic testing
		of the PCL board.
Controller	140	PCL board detected an error during the internal diagnostic testing
		of the PCL board.
	145	PCL board detected an error during the internal diagnostic testing
		of the PCL board.
	160-182	PCL board detected an error during the internal diagnostic testing
		of the PCL board.
	199-215	PCL board detected an error in the communication between the
		PCL board and the IGS board.
	301-401	IGS board detected an error during the internal diagnostic testing
		of the IGS board.

Printer and Troubleshooting Overview 1-9