14 Turn the printer off.
•Disconnect J/P42.
•Check
Is there continuity to ground?
No: Replace the operator panel circuit board, then turn to TAG 002: Check & Problem Resolution .
Yes: Repair or replace the connectors or wiring from
15 Turn the printer off.
•Reconnect J/P330.
•Disconnect J/P331.
•Turn the printer on.
•Check
Is the voltage +5 Vdc?
No: Go to #17 in this TAG.
Yes: Continue.
16 Turn the printer off.
•Reconnect J/P331.
•Disconnect J/P306.
•Turn the printer on.
•Check
Is the voltage +5 Vdc?
No: Repair or replace the connectors or wiring from
Yes: Replace the duplex control board #1, then turn to TAG 002: Check & Problem Resolution .
17 Turn the printer off.
•Reconnect J/P331.
•Disconnect J/P333.
•Turn the printer on.
•Check
Is the voltage +5 Vdc?
No: Go to #20 in this TAG.
Yes: Continue.
18 Does the printer have an attachment option?
No: Replace the signal interface board, then turn to TAG 002: Check & Problem Resolution.
Yes: Continue.
Troubleshooting Analysis Guide (TAGs) |