Bench Test Procedure
The bench test procedure references the component acronyms in Table
Figure
To bench test the
1 Turn the printer’s main power switch off.
2 Remove the output tray from the stacker unit.
3 Disconnect the stacker unit’s power cord from the printer and from the stacker, then disconnect the unit’s control connector cable from the printer’s jack.
4 Remove the stacker unit from the printer, then place it on a work bench or other suitable surface.
5 Remove the printer’s power cord from the wall outlet and the printer’s lower back cover.
6 Observe the pin configuration of the stacker unit’s control connector cable plug .
1 2 3 4 5 6 7
Plug
9 10 X X X X X
Control Connector Cable
Options |