10 Run test prints. Use extreme caution:
•Check
Is the voltage 100 vac?
No: Continue.
Yes: Replace the vacuum transport unit, then turn to TAG 002: Check & Problem Resolution.
11 Run test prints. Use extreme caution:
•Check
Is the voltage 100 vac?
No: Replace the power control #2 board, then turn to TAG 002: Check & Problem Resolution .
Yes: Repair or replace the connectors or wiring from
12 Inspect the fuser drive assembly and the fuser drive belt for damage or a slipping belt.
Are they in good working order?
No: Replace the parts that are defective, then turn to TAG 002: Check & Problem Resolution.
Yes: Replace the printhead assembly, then turn to TAG 002: Check & Problem Resolution.
Troubleshooting Analysis Guide (TAGs) |