Is there continuity on each?
No: Replace wire harness W46, then turn to TAG 002: Check & Problem Resolution.
Yes: Continue.
20 Check for continuity to ground:
Is there continuity to ground on any?
No: Replace the disk drive assembly, then turn to TAG 002: Check & Problem Resolution.
Yes: Replace wire harness W46.
21 Is error code 130, 131, 133, or 134 displayed?
No: Continue.
Yes: Replace the PCL board, then turn to TAG 002: Check & Problem Resolution.
22 Can the printer run test prints?
No: Continue.
Yes: Replace the disk drive assembly. If this resolves the problem, turn to TAG 002: Check & Problem Resolution. If this does not resolve the problem, replace the IGS board, then turn to TAG 002: Check & Problem Resolution.
23 Turn the printer off and unplug the power cord.
•Disconnect J/P31 and J/P79.
•Check
Is there continuity?
No: Replace the disk drive assembly. If this resolves the problem, turn to TAG 002: Check & Problem Resolution. If this does not resolve the problem, replace the IGS board, then turn to TAG 002: Check & Problem Resolution.
Yes: Replace wire harness W46, then turn to TAG 002: Check & Problem Resolution.
Troubleshooting Analysis Guide (TAGs) |