8 Check
Is there continuity?
No: Repair or replace the connectors or wiring from P41- 21 to
Yes: Continue.
9 Reinstall the fuser unit.
•Check
Is the resistance between I KΩ and 400 KΩ?
No: The new fuser unit seems to be defective. Replace it with a new fuser unit, then turn to TAG 002: Check & Problem Resolution.
Yes: Replace the PCL board, then turn to TAG 002: Check & Problem Resolution.
10
•Check
Is the voltage +24 Vdc?
No: Go to #16 in this TAG.
Yes: Continue.
11 Turn the printer off.
•Continue to check
•
Does the voltage drop from +24 Vdc to 0 Vdc during the 15 seconds following the output tray jogging test?
No: Go to #24 in this TAG.
Yes: Continue.
12
•Check
Is the voltage at least 100 Vac?
No: Go to #15 in this TAG.
Yes: Continue.
Troubleshooting Analysis Guide (TAGs) |