Job Offset Assembly Removal
5Remove the DC power supply (See page
6Remove the mounting bracket for the DC power supply (two screws).
7Remove the fuser drive cover (three screws).
8Disconnect CN19 and CN54.
9Remove the five screws holding the job offset assembly in place (three front and two back).
10Remove the fuser drive cover mounting post.
11Remove the output option mounting pin (single screw, located on the front of the printer).
12Remove the job offset assembly.
Fuser Drive
Cover
Bracket
| CN19 |
Mounting |
|
Pin |
|
| CN54 |
| Fuser Drive Cover |
| Mounting Post |
Bracket Mounting Screws | Mounting Screws |
Right Side Detail | Back Detail |
Removal/Replacement Procedures |