This section provides
Follow these steps to access the
1Turn off the printer and wait five seconds.
2Hold down the STOP and TEST keys simultaneously as you turn the printer back on. Continue to hold the keys down until O appears on the display. The STANDBY light flashes as the printer accesses its soft diagnostic mode, which takes approximately 1 minute. The tone, followed by 001 on the display, indicates you can now run a test.
3Change the counter to the number of the test you wish to run by pressing CANCEL to increase the counter or # TEST to decrease the counter. If you press these keys before a test is complete, a long tone sounds and the test continues without interruption.
4Press READY to run the test.
5Press STOP to end the test (in most cases; see specific diagnostic procedures for direc- tions on exiting a test).
6To exit diagnostic mode, cycle printer power.
•Most errors or conditions reported are valid for about 90 seconds, which is the timeout period set for most of the diagnostic tests described in this section.
Note
Only diagnostics useful for field maintenance are documented in this manual.Diagnostic Tests |