Bissell 89Q9, 18Z6 Maintenance and care, Empty dirt container, Empty dirt into garbage container

Maintenance and care

To maintain maximum cleaning performance, the following maintenance steps must be performed:

1.Empty the dirt container when the dirt reaches the “Full” line on the front.

2.Check the pre-motor filter at least once a month and clean and replace as needed.

3.Replace the HEPA media post-motor filter every six months.

NOTE: More frequent filter cleaning may be necessary if you are vacuuming new carpet, fine dust, or have allergy concerns.

Follow the instructions on the following pages to perform these simple maintenance steps.

4.Allow parts to dry completely before returning them back into the vacuum.

WARNING:

To reduce the risk of electric shock, turn Power Switch OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.

Tip:

For maximum cleaning performance, check and clean or replace all filters as suggested.

Empty dirt container

The dirt container needs to be emptied when the dirt reaches the “Full” line on the front of the container.

1.Unplug cleaner from electrical outlet.

2.Slide the Lock ‘n Seal Lever to the “Unlock” position.

3.Grasp handle and pull the dirt container straight out to remove from vacuum.

4.Empty dirt into garbage container.

5.Put the dirt container back in the vacuum and slide the lever to the “Lock” position.

The dirt container may be washed in warm water with a mild detergent. Make sure it is completely dry before replacing.

Unlock Position

Full Line

Lock

Position

10 w w w . b i s s e l l . c o m

DJ68-00250K(EN)-0.1.indd 10

8 0 0 . 2 3 7 . 7 6 9 1

2009.2.28 11:37:2 AM