Bissell 89Q9, 18Z6 warranty Cleaning clogs

Page 14

Maintenance and care

Cleaning clogs

4.

Low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor or a reduction in the spinning action, check for clogs.

1.Unplug cleaner from electrical outlet.

2.Empty Dirt Container.

3.Check Upper Tank for build up or clogs.

4.Remove the secondary cyclone and check the suction inlet for a clog.

5.Grasp the Hose Grip and lift to separate from the suction opening. Check for a clog in the Base or the Hose.

6.Release the Twist n' Snap hose from the vacuum by turning to the left. Straighten the hose and unclog with a long, narrow object such as a broomstick.

7.If the low suction persists, follow the instructions for Checking the Rotating Brush on page 11 and inspect the Air Passageway for obstructions.

14 w w w . b i s s e l l . c o m

Suction

Inlet

5.

Suction

Opening

7.

Air Passageway

8 0 0 . 2 3 7 . 7 6 9 1

DJ68-00250K(EN)-0.1.indd 14

2009.2.28 11:37:6 AM

Page 13 Page 15
Image 14
Page 13 Page 15
Contents
Consumer Services Additional Accessories Replacement Parts Safety Instructions Product View Assembly OperationsTroubleshooting E R ’ S G U I D EThank you for buying a Bissell Multi Cyclonic vacuum Important Safety Instructions Or injuryProduct view Attach handle to vacuum How to use this guideAssembly Attach vacuum hose and toolsHandle position Power switch/brush switchOperation Storage clips as shownPlace handle in upright position Power height adjustmentSpecial tools Length of the strap may be adjusted as required for comfort Pet TurboBrushTurn vacuum cleaner off O Power cord storageTransporting Cleaner Loop power cord around cord wraps on side of the canisterReplace the Hepa media post-motor filter every six months Maintenance and careEmpty dirt container Empty dirt into garbage containerUnplug the vacuum from electrical outlet Cleaning the pre-motor and post-motor filterUnplug the cleaner from electrical outlet Pulley Unplug cleaner from electrical outletClean debris from the motor pulley and drive belt areas Reposition lens and secure with the one screw TurboBrush maintenanceReplace light bulb Cleaning clogs Refer to the Clearing Clogs section Turn the cleaner OFF O and unplug from electrical outletThermal protector No power at rotating floor brush TroubleshootingVacuum cleaner won’t run Vacuum cleaner wont pick up dirtVisible dirt escaping from cleaner Contact us directly at98Q1-A Bissell consumer serviceAdditional accessories Monday FridayPart Name StyleWarranty If your Bissell product should require service
Related manuals
Manual 20 pages 3.12 Kb