Bissell 8990, 3591 Handle Positions, Power Height Adjustment, Lowest Setting For bare floors

Page 6

Attach Vacuum Hose and Tools Continued

Slide the Extension Wand and the Crevice Tool together

4. into the storage clip as shown.

5.

Slide the Dusting Brush Tool into the storage clip as shown.

How To Use Your BISSELL CleanView®

Handle Positions

Note:

The Floor Brush will continue to rotate while you use your vacuum for above floor cleaning. To prevent carpet damage, do not lean on the vacuum or let the Powerfoot tilt forward.

1.

Press the Handle Release Pedal with your foot to place your CleanView into one of three cleaning positions.

Upright- For storage and above floor cleaning with tools.

Normal Cleaning- Press Handle Release Pedal once. Use

CAUTION:

Before using your vacuum, make sure that the Dirt Container and Upper Tank are in locked position and that all filters (Pre-Motor and Post-Motor) are in place. Do not operate your vacuum without these filters.

2. for most household floor cleaning tasks.

Low Cleaning- With the vacuum in normal cleaning position,

3. press Handle Release Pedal again. Use for reaching under low furniture such as tables, chairs or beds.

1

2

Power Height Adjustment

The Powerfoot/Rotating Floor Brush on your BISSELL CleanView can be adjusted to clean several floor surfaces.

3

Tip:

Before cleaning under low

1.

2.

NOTE: For optimal cleaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting.

Place Handle in Upright Position.

Turn Height Adjustment knob to desired setting.

Lowest Setting - For bare floors.

Medium Settings - For short and medium pile carpets.

Highest Setting - For plush pile carpet.

Place the Handle into the Normal Cleaning Position and

furniture, check area first for objects that might harm the unit or block the Vacuum Hose.

Tip:

Your BISSELL CleanView features a Quick-Release Cord Wrap. To remove the

3. the Powerfoot will adjust to the setting chosen.

NOTE: You may also adjust the setting while in the Normal Cleaning Position.

6

Power Cord quickly and easily, rotate the Upper Cord Wrap towards floor, and slip Power Cord from Upper and Lower Cord Wraps.

Image 6
Contents CleanView 3590/3591/8990 SeriesThanks for buying a Bissell CleanView Mark J. Bissell President and Chief Executive OfficerImportant Safety Instructions U T I O N Attach Handle To Vacuum How To Use This GuideHow To Put It Together Attach Vacuum Hose and ToolsHighest Setting For plush pile carpet Power Height AdjustmentLowest Setting For bare floors Handle PositionsDusting Brush Tool Transporting CleanerSpecial On-Board Tools Crevice ToolFull Line Power Cord StorageEmpty Dirt Container UnlockPre-Motor Cleaning The Upper Tank & LouversCleaning The Pre-Motor and Post-Motor Filters FilterReplace Drive Belt Power Trak models onlyCheck Rotating Floor Brush and Drive Belt Air PassagewayThermal Protector Replace LightbulbClearing Clogs Suction Inlet Air PassagewayVacuum cleaner is difficult to push TroubleshootingVacuum cleaner wont run Visible dirt escaping from cleanerMail us at canada.custhelp@bissell.com Bissell Customer ServicePart Name 56/7 1011Warranty Limited One Year WarrantyIf your Bissell product should require service