Power Cord Storage
When you are done using your BISSELL CleanView, return it to the Upright position and store the Power Cord.
1. Turn vacuum cleaner off.
2. | Unplug Power Cord by grasping the polarized plug (NOT the | ||
cord) and disconnect from outlet. | |||
|
| Loop Power Cord around Cord Wraps on side of | |
3. | |||
vacuum cleaner. | |||
|
|
| |
4. | Clip molded plug to Power Cord to secure. | ||
NOTICE:
While vacuuming, certain carpets and low humidity conditions may generate small static discharges. The discharges are entirely harmless and are not associated in any way with the main power supply.
How to Maintain Your BISSELL CleanView®
To maintain maximum cleaning performance, the following maintenance steps must be performed:
1. | Empty the Dirt Container when the dirt reaches the “Full” line |
on the side. |
2. Clean or replace the
3. Clean or replace the Post-Motor Filter every 3 months.
More frequent filter cleaning may be necessary if you are vacuuming new carpet, fine dust, or have allergy concerns. Follow the instructions on the following pages to perform these simple maintenance steps.
Empty Dirt Container
The Dirt Container needs to be emptied when the dirt reaches the Full line on the side of the Container.
WARNING: To
reduce the risk of electric shock, turn Power Switch OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.
Tip:
For maximum cleaning performance, Check and clean or replace all filters
as suggested.
1.
2.
Unplug cleaner from electrical outlet.
Full Line
Slide the Lock ‘n Seal Lever to the "Unlock" position. | Unlock | Lock Position |
| Position |
|
Grasp handle and pull the Dirt Container straight out to remove
3. from vacuum.
4. Empty dirt into garbage container.
5. | Put the Dirt Container back in the vacuum and slide the lever to |
the "Lock" position. |
Note: The Dirt Container may be washed in warm water with a mild detergent. Make sure it is completely dry before using again.
8