Cleaning The Upper Tank & Louvers
1. | Unplug the cleaner from electrical outlet. |
The Upper Tank area can be reached by removing the
2. Dirt Container, reaching underneath the Upper Tank and turning the Louver Cap to unlock. Pull straight down to remove. Brush the dirt off the Louvers and Upper Tank area.
3. | The Upper Tank and Louvers may be wiped clean with a |
damp cloth. |
Note: For easier access, the entire Upper Tank may be removed by turning the knob on the back of the cleaner to unlock and pulling the entire tank straight out.
Cleaning The Pre-Motor and Post-Motor Filters
Use only BISSELL Replacement Filters in your BISSELL CleanView.
|
|
|
|
HEPA Media |
1.
The
2. It is located in the slide out tray underneath the Dirt Con- tainer. If the filter becomes dirty, pull out the tray, lift out the filter and clean.
The
3. return clean air to the room. It is located behind the door on the side of the cleaner. If the filter becomes dirty, open the door, remove the filter and clean.
Note: Select Models come with a white, pleated HEPA Media Filter. This filter is not washable and must be replaced.
The standard filters may be hand washed in cold water
4. with mild detergent. Rinse well and air dry thoroughly before replacing.
W A R N I N G :
Do Not operate cleaner with damp or wet filters or without all filters in place.
| ||
Filter | ||
Filter | ||
|
W A R N I N G :
To reduce the risk of injury from moving parts, turn off vacuum cleaner and disconnect Power Plug from electrical outlet.
9