Maintenance and care
Replacing the post-motor filter
The
1.Turn power OFF. Unplug vacuum cord from electrical outlet.
2.Locate filter behind the door on the side of the vacuum. Remove and replace when fil- ter becomes dirty. The white, pleated HEPA media filter is not washable.
Open | Remove | |
Filter | ||
Door | ||
|
Checking rotating floor brush and drive belt
Check your vacuum's rotating floor
brush and drive belt regularly for3. wear or damage.
1.Turn power OFF. Unplug vacuum cord from electrical outlet.
2. Place handle in low position and turn vacuum cleaner over so bottom side is up.
3.Remove the seven screws with a Phillips
head screwdriver. Lift the brush cover off.
4. Grasp rotating floor brush at both ends and |
|
lift. | Brush Cover |
|
5.Clean strings, hair and other debris from
rotating floor brush, paying particular | 8. |
attention to brush ends. |
|
6.Clean strings, hair and other debris from motor pulley and drive belt areas.
7.Check drive belt carefully for wear, cuts or stressed areas.
8.Check air passageway for obstructions.
Remove debris from this area. | Air Passageway |
12
w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |