Maintenance and care
Check rotating floor brush and drive belt cont.
4.Grasp rotating floor brush at both ends and lift.
5.Clean strings, hair and other debris from rotating floor brush, paying particular attention to brush ends.
6.Clean strings, hair and other debris from motor pulley and drive belt areas.
7.Check drive belt carefully for wear, cuts or stressed areas.
8.Check air passageway for obstructions. Remove debris from this area.
Replace drive belt
Use only genuine BISSELL style 9 replacement belts (#32074) in your BISSELL Velocity Bagged vacuum.
1.Unplug the cleaner from electrical outlet.
2.With rotating floor brush removed from vacuum cleaner (steps
3.Place new drive belt over motor pulley and stretch other end over rotating floor brush in the space between the bristles.
4.Place ends of rotating floor brush down into slots on sides as shown.
5.Turn rotating floor brush by hand several times in the direction of motor pulley.
If properly installed, the drive belt will center itself on the rotating brush.
6.Reposition brush cover and screw back into place.
Motor Pulley
6.
8.
Air Passageway
4.
Motor
Pulley
11
w w w. b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |