How to use this guide
This User’s Guide has been designed to help you get the most satisfaction from your BISSELL PowerForce Turbo Bagless. You’ll find assembly and operating instructions, safety precautions, as well as maintenance and troubleshooting instructions. Please read this User's Guide thoroughly before assembling your vacuum cleaner.
Pay particular attention to the product diagram, assembly instructions, and part names. Locate and organize all parts before assembly. Following this User’s Guide will greatly enhance your ability to get the most performance from your BISSELL PowerForce Turbo Bagless for many years.
Assembly
WARNING:
Plastic film can be dangerous. To avoid danger of suffocation, keep away from babies and children.
The only tool you’ll need to assemble your vacuum cleaner is a screwdriver.
Attach handle to vacuum
1.Locate the vacuum handle and remove the screw packet taped to the base of the handle.
2.Stand the vacuum upright and place the handle on the top of the vacuum body.
3.Insert the screws into the existing holes on each side. Tighten securely with a screwdriver.
Attach vacuum hose and tools
1.Attach the Twist ‘n Snap hose by lining up the tabs on the base with the corresponding
notches on the back of the vacuum.
2.Turn the Twist ‘n Snap hose to the right to lock the hose into place.
3.Grasping the Quick Reach handle, slide the end of the hose wand into the hose wand base. Snap the hose into the hose clip.
NOTE: The powerfoot will not operate effectively unless the hose wand is firmly attached.
4.Slide the extension wand and the crevice tool together into the storage clip on the side of the vacuum.
5.Snap the combination tool into the storage clip on the back of the vacuum.
6.The TurboBrush bracket slides into the front of
the handle. Attach the bracket by aligning the pegs with the holes on the handle and pulling down until it locks into place.
w w w . b i s s e l l . c o m |
| 5 |
|
10/14/08 2:39:49 PM