Maintaining the TurboBrush, Media Post-Motor Filter

Maintenance and care

Replacing the HEPA media post-motor filter

Use only BISSELL Style 12 HEPA filter in your

BISSELL PowerForce Turbo Bagless.

1.Unplug cleaner from electrical outlet.

2.The HEPA media post-motor filter assists in the filtration process to return clean air to the room. It is located behind the door on the front of the cleaner. When the filter becomes dirty, open the door, remove the filter and replace.

Note: This filter is not washable and must be replaced.

3.Replace the door by inserting the tabs on the left side and snapping the right side into place.

Maintaining the TurboBrush

The TurboBrush should be checked regularly for clogs or debris wrapping around the brush roll.

1.Remove TurboBrush tool from hose or front of vacuum.

2.Twist collar so opening is at the top and lift top cover to remove.

3.Remove brush from belt and clean debris.

4.Replace brush inside belt and place ends into slots on sides.

5.Reposition top cover, making sure to line up the inside tab at the front with the opening on the cover. Twist collar until opening is at the bottom to lock into place.

10 w w w . b i s s e l l . c o m

HEPA

Media

Post-Motor

Filter

WARNING:

To reduce the risk of injury from moving parts, turn the power switch OFF and disconnect plug from electrical outlet.

ug110-4049_82H5_1008.indd 10

10/14/08 2:40:38 PM