Sharp R-1900J Procedure, Operation when Programme Lock ON is set, To Set the Signal Type

*Suppose you want to set Programme Lock ON.

Procedure

1Press the CUSTOM SETTING pad

x 2 twice within 2 seconds.

3	2	2	Enter 3, 2 for Programme Lock
			ON.
		3	Press the START pad to save the
			setting.

4 Press the STOP/CLEAR pad to exit from the Custom Setting function.

NOTE : If you select Programme Lock OFF, the LOCK indicator in the display will disappear when you press the START pad.

Operation when Programme Lock ON is set

KEY	Custom Setting Title	When Programme
Operation		Lock ON is Set
1	Selecting Memory	no operation
	Input Method
2	Selecting Auto Start	no operation
	Operation
3	Programme Lock	operation
	Setting
4	Audible Signal Sound	no operation
	Volume Setting
5	Cooking Completion	no operation
	Signal Setting
6	Memory Check	operation
	Counter Check/Clear	check : operation
7		clear :
		no operation
	Air Intake Filter	check, clear :
8	Counter	operation
		set : no operation
	Selecting Operation	no operation

9in Case of Magnetron Failure

	Multiplication Factors	check : operation
x2/x3	for Double/Triple	set : no operation
	Quantity
EXPRESS	Express Defrost	check : operation
DEFROST	Setting	set : no operation

10

4. Audible Signal Sound Volume Setting

The volume of the audible signal can be adjusted to High, Medium, or Mute.

CU41 : High = factory Setting

CU42 : Medium

CU43 : Mute

To Set Cooking Completion Signal Volume

Press the CUSTOM SETTING pad twice within 2 seconds then enter the numbers

4, 1 for High

4, 2 for Medium 4, 3 for Mute

Press the START pad to save setting and the STOP/CLEAR pad to exit from the Custom Setting function.

NOTE : Even when errors occur, your oven will not beep in mute setting.

5. Cooking Completion Signal Setting

There is a choice of 4 different signals on your oven. CU51 : 1 long beep = factory setting

CU52 : Repeating long beeps

CU53 : 4 short beeps

CU54 : Repeating short beeps

To Set the Signal Type

Press the CUSTOM SETTING pad twice within 2 seconds then enter the numbers

5, 1 for 1 long beep

5, 2 for repeating long beeps 5, 3 for 4 short beeps

5, 4 for repeating short beeps

Press the START pad to save settings and the STOP/CLEAR pad to exit from the Custom Setting function.

6. Memory Check

Use this setting to check the programming for a certain memory.

*Suppose you want to know the information programmed into memory 1, programmed for 4 minutes at 60% for the 1st stage and 2 minutes at 30% at the 2nd stage programmed Dual Digit Input.

ProcedureDisplay

x 2 6

1 Press the CUSTOM SETTING	NO. CHECK
pad twice within 2 seconds and
enter 6.

R-1900J [EN].indd Sec1:10

4/28/09 10:01:26 AM