Bissell 79T3 warranty Troubleshooting, Reduced Spray or No Spray, No spray through the hose

Troubleshooting

Reduced Spray OR No Spray

Possible cause

1.Clean water/formula tank may be empty

WARNING:

To reduce the risk of fire, electric shock or injury, unplug from the outlet before servicing.

Remedies

1.Turn power switch off; refill tank with clean hand hot tap water and formula

2.	Clean water/formula tank may not be seated properly	2.	Turn power switch off; remove tank
			and reseat
3.	Pump may have lost prime	3.	Turn power switch off; after 1 minute
			turn on and depress spray trigger
			Be sure there is cleaning formula in the
			clean water/formula tank, it will make the
			machine prime faster
4.	Spray tip may be clogged	4.	Remove spray tip and rinse thoroughly
			under hot water. Replace with the o-ring tip
			going down into the machine
No spray through the hose
Possible cause		Remedies
1.	Pump may not be primed	1.	Turn ReadyTools dial to FLOOR CLEANING
			and depress spray trigger for a few a
			seconds until you see suction coming up
			the nozzle
			Turn ReadyTools dial back to TOOLS
PowerRoller Does Not Turn
Possible cause		Remedies
1.	The brush belt is off or broken	1.	Refer to page 11, steps 1-5 for instructions
			on how to access the belt
		2.	Look at the belt and check for breakage or
			mis-alignment on the cogs. If there is no
			evidence, replace all parts following steps 8-10.
		3.	In the event your belt is broken, a replacement
			belt may be ordered at www.bissell.com or by
			calling BISSELL consumer services. Refer
			to the parts list on page 14. Complete installation
Machine not picking up solution			instructions will come with the replacement belt
Possible cause		Remedies
1.	Dirty water tank may not be seated properly	1.	Turn power switch off; reseat tank
2.	ReadyTools dial may be on TOOLS	2.	Turn ReadyTools dial to FLOOR CLEANING
3.	Float may have shut off	3.	Turn power switch off and empty tank if
			necessary. If tank is not full, wait
			30 seconds and turn power switch on
4.	Dirty water tank may be full	4.	Turn power switch off and empty tank

Other maintenance or service not included in the manual should be performed by an

authorized service representative.

Thank you for selecting a BISSELL product.

Please do not return this product to the store

12 w w w . b i s s e l l . c o m