Operation
ReadyTools™ (continued)
2.Check for colorfastness in an inconspicuous place.
3.If possible, check upholstery stuffing. Colored stuffing may bleed through fabric when wet.
4.Plan activities to give upholstery time to dry.
5.Vacuum thoroughly to pick up loose debris and pet hair. Use a vacuum with a brush attachment and a crevice tool to clean in fabric folds and tufts.
6.To start cleaning with attachments, follow the instructions on page 7, beginning with "Fill the clean water/formula tank".
7.Set the ReadyTools dial to the TOOLS setting. This will allow for suction from the hose.
8.Attach the desired cleaning tool to the end of the hose.
9.Clean by pressing the spray trigger to spray cleaning solution onto the area to be cleaned. Slowly move the tool back and forth over the soiled surface. Release the spray trigger to suction dirty water. Continue to clean in the area, working in small sections, until dirt is removed.
Caution: Do Not Overwet.
10.When finished cleaning, remove and rinse the tool(s) in clean, running water.
11.It is recommended that you suction clean water from the tap to rinse out the hose.
12.Before wrapping hose onto tool rack, lift end of hose and stretch out to ensure all water is cleared from hose.
13.Wrap hose around tool rack.
14.Empty dirty water tank and rinse out, following instructions on page 8.
15.If the ReadyTools dial becomes difficult to turn, the diverter assembly that holds the dial may need to be cleaned. To clean, flush hot water through the nozzle. Make sure the dial is set to FLOOR CLEANING.
w w w . b i s s e l l . c o m
9