Operation
Before you clean
1.If desired, move furniture to another area if cleaning an entire room.
2.Vacuum area with a dry vacuum cleaner before cleaning.
3.Plan your cleaning route to leave an exit path. It is best to begin cleaning the corner farthest from your exit.
Fill the clean water/formula tank
1.Remove the clean water/formula tank from the base of the machine by pulling up and out from the back. You can also detent the handle and pull the tank straight up if you desire.
2.Unscrew the black cap and red insert. Remove and set aside.
3.Fill the tank up to the FILL LINE with hand hot tap water.
4.Add 3 ounces of formula (always use genuine BISSELL formulas to maximize cleaning and for the safety of your machine).
5.Replace the cap and insert and tighten by turning clockwise.
6.Replace the clean water/formula tank back into the machine. Be sure that the cap is seated in the receiver.
Carpet washing
1.Make sure the ReadyTools Dial is in the FLOOR CLEANING position.
2.Plug the ReadyDry into the proper outlet and turn the power on using the switch in the back.
3.With your foot, press the gray handle release lever located on the back of the unit. Take care to notice the way the machine floats forward.
4.While pressing the spray trigger make one forward wet pass and another one back. Repeat once and move on to the next section of carpet or area rug to be washed. Take care not to run over loose objects of the edges of area rugs.
| EXIT |
|
| 9 |
|
|
|
| 11 | 10 |
|
| |
| 12 |
|
|
| ||
|
|
|
|
| ||
|
|
|
|
|
| |
5 |
| 6 |
| 7 |
|
|
|
|
|
| 3' | ||
|
|
|
| 1 | ||
|
|
|
|
| T | |
|
|
|
|
| AR | |
|
|
|
| 2 | ST |
|
|
|
|
| HERE | ||
|
| 3 |
|
| ||
4 |
|
|
|
| 4' | |
|
|
|
|
|
| |
Tip: Thorough vacuuming before carpet washing will prevent early clogging of the lint screen.
w w w . b i s s e l l . c o m
7