8. Remove the “toothed” brush belt from the brush then from the red pump pulley. Set the “toothed” brush belt and brush aside.
Pump Belt and Brush Belt Replacement
1. Turn the machine off and unplug from wall outlet.
2. Step on the release pedal and recline the handle down onto floor. (see illustration).
3. Remove the Tank-in-Tank and SmartMix tanks. Set them aside (see illustration).
4. Remove Belt Access Door located near the Floor Cleaning/ Tools switch by inserting a flat head screwdriver into the slot nearest to the handle and gently prying the access door off (see illustration).
5. Turn the machine onto its side so the belt access area is facing upward (see illustration).
6. On the bottom of the machine, near the belt access area, is a red retainer plate that holds the black brush arm and brush in place. Using a Phillips head screwdriver remove the screw that holds the red retainer plate in place. Set red retainer plate and Phillips head screw aside (see illustration).
Store cleaner upright in a protected, dry area.
8.
9.
10. When carpet is dry, vacuum again to remove hair and fuzz that the POWERSTEAMER may have loosened.
Wipe all exterior surfaces with a soft cloth.
Note: SmartMix tank may be stored with concentrate ready for your next cleaning job. Make sure dial is set to Water Only
Rinse out the Tank-in-Tank and replace on the machine.
Remove Tank-in-Tank, dispose of dirty water.
4. Coil flex hose around storage brackets on tool caddy.
5.
6.
7. Clean out the Flow Indicator Filter each time it is used to insure best cleaning performance. Unscrew the Flow Indicator Cap, lift out the red Rotor and white Filter. Rinse all three parts in tap water. Replace the Filter and Rotor. Replace the Flow Indicator Cap; turn until snug, do not over-tighten.
Maintenance/Storage
1. Turn Power switch OFF.
2. Unplug power cord from the outlet and coil around Power Cord Quick Release.
3. Remove and rinse tools in clean, running water, let dry and replace in tool caddy.
Tip:
SmartMix tank may be stored with concentrate ready for your next cleaning job. Make sure dial is set to Water Only.
Set
dial to:
Cap Rotor
Filter
CAUTION:
PowerSteamer uses water and must not be stored where there is a danger of freezing. Freezing will damage internal components and void the warranty.
23 Tank-
3
5
7. Remove the black brush arm that holds the brush in place.
SmartMix®
4
6
Set the black brush arm aside (see illustration).
9.Locate and remove the broken pump belt.
WARNING:
7
8
9
| To reduce the risk of fire, electric shock or injury, |
12 | unplug appliance from outlet before servicing. |
|
12/21/05 3:51:41 PM |