Bissell 8804 Troubleshooting, To Install The Replacement Pump Belt, Assembly is now complete

Page 13

1.

To Install The Replacement Pump Belt

1.With the unit still on its side, loop one end of the replacement pump belt around the red pump pulley and then the other end around the silver motor shaft (see illustration). Do not twist the replacement pump belt.

2.Re-install the toothed brush belt first onto the red pump pulley 2.

and then onto the toothed end of the brush (see Illustration).

3. Re-install the brush into the base of the unit.

4.Place the black brush arm onto the brush and slide black brush arm into base of unit. The black brush arm and brush

should slide easily into original position (see illustration).	4.

5. Re-install the red retainer plate and Phillips head screw (see illustration).

6.Using your finger, gently spin the replacement pump belt on

the silver motor shaft. If assembled correctly, the replacement pump belt should rotate freely around the silver motor shaft

and drive pulley without obstruction. The brush should also 6. rotate freely when the silver motor shaft is turned.

7. Turn the machine right side up and replace the Tank-in-Tank, Smart Mix tank and belt access door (see illustration).

8.Assembly is now complete.

If you have any questions, or are having trouble installing

7b

your replacement pump belt, please call BISSELL Consumer Services at 1-800-237-7691.

3.

5.

7a

Troubleshooting

Reduced Spray Or No Spray.

Possible Causes

1Bladder may be empty.

2SmartMix tank may be empty.

3The Flow Indicator Filter may be clogged.

4Tank-in-Tank may not be seated properly.

5Pump may have lost prime.

ug310-5926_1697_1205.indd 13

WARNING:

To reduce the risk of fire, electric shock or injury, unplug appliance from outlet before servicing.

Remedies

1Turn power OFF; refill tank with hot tap water.

2Turn power OFF; clean out lint screen, follow SmartMix instructions on page 6.

3Clean Out Filter; follow Steps under Maintenance/Storage on page 12.

4Turn power OFF; remove tank and check gasket on tank bottom, reseat tank.

5Turn power OFF; after 1 minute, turn ON and depress Spray trigger.

13

12/21/05 3:51:42 PM

Image 13

Contents

PowerSteamer Series Thanks For Buying a Bissell PowerSteamer Deep Cleaner Do not leave machine when it is plugged Read all instructions before using yourDo not immerse Do not use with damaged cord or plugProduct View Basics How Your PowerSteamer Works How To AssembleSmartMix Choose the SmartMix setting that fits the cleaning job DirtLifter PowerBrushTank-in-Tank Carry it like a bucket to fill at the sinkRemove the Tank-in-Tank follow steps 1 Pour Out Emptying Tank-in-TankCarry the Tank-in-Tank, like a bucket, to the sink where You will dispose of the dirty waterFlow Indicator How To Clean CarpetReadyTools Dial Plug into a proper outlet and turn the Power switch on Normal Cleaning Machine Preparation Pre-Treating OptionalCleaning Technique Cleaning Fluid SectionImportant Check Upholstery Tags Tilt Handle Back Handle Release Carrying Remove the black brush arm that holds the brush in place Cap Rotor FilterTo Install The Replacement Pump Belt TroubleshootingRe-install the brush into the base of the unit Assembly is now completePoor tool position. Handheld attachments only Reduced Spray Or No SprayReplacement Parts Bissell Consumer ServicesTank Assembly Complete Replacement Brush BeltAbout Your Warranty Limited One Year Warranty