Troubleshooting (Continued)
Reduced Spray Or No Spray (Continued).
Lift Here
Insert Screwdriver Blade Here
Possible Causes | Remedies |
6The Pump Belt may be broken.
6Turn the machine OFF and unplug
from the outlet. To check if a Pump Belt has broken, you will need a flat
head screwdriver. Insert
the blade end into the lower slot of the Belt Access door to release the lower snap. If necessary, insert the blade end into the upper slot
to release the upper snap. Examine the belt for breakage. You should be able to see the Pump Belt looped around the motor shaft. If it is broken or missing, please refer to Replacement Parts on page 15 before calling Consumer Services. Complete installation instructions will accompany the replacement belt.
PowerSteamer is not picking up solution.
Possible Causes | Remedies |
1ReadyTools Dial may be at the wrong setting for cleaning job.
2Nozzle Window may not be properly attached.
3
4
5Poor tool position. (Handheld attachments only)
6Tank-in-Tank has picked up the maximum dirty water.
1Set ReadyTools Dial to either FLOOR CLEANING or TOOLS/PRETREAT.
2Make sure the two tabs on the back of the Floor Nozzle Window are inserted through the mating slots in the main housing. Reinstall
if necessary.
3Reinstall lid; refer to page 6.
4
5Readjust angle; apply more downward pressure.
6Empty tank and refill; refer to
page 7.
Thank you for selecting a BISSELL product.
If you should happen to need assistance during assembly or operations, call
Please do not return this product to the store
14
12/21/05 3:51:43 PM |