Maintenance and care
Clearing clog
The Hose on the back of the vacuum cleaner that carries the dirt from the powerfoot to the dust bag can sometimes become clogged. If you notice a change in the sound of the vacuum motor, check for clogs.
1.Unplug cleaner from electrical outlet.
2.Pull the bag door outward to open and set aside. Remove the dust bag to check the suction Inlet for a clog.
3.Grasp the quick reach handle and lift up to separate from the suction intake opening. Check for a clog in the base, the wand or the hose.
4.Release the hose from the vacuum by turning to the right. Straighten the hose and unclog with a long, narrow object.
5.If the clog persists, turn the vacuum cleaner OFF and unplug it. Remove the brush cover. Check the air passageway for obstructions. Remove debris from this area. Reposition brush cover and four screws. Tighten screws securely. Make sure end of brush cover is snapped into place.
Troubleshooting
Vacuum cleaner won’t turn
Possible causes
1.Power cord not firmly plugged in
2.Blown fuse/tripped breaker
Suction
Inlet
Air Passageway
WARNING:
To reduce the risk of electric shock, turn power OFF and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting.
Remedies
1.Check electrical plug
2.Check/replace fuse or reset breaker.
Vacuum cleaner won't pick up dirt
Possible causes
1.Incorrect height adjustment
2.Hose not attached to suction opening
3.Twist 'n Snap hose not securely attached
4.Dust bag is full
5.Rotating floor brush bristles worn
6.Rotating floor brush jammed
7.Clog in vacuum
10 w w w . b i s s e l l . c o m
Remedies
1.Adjust powerfoot to correct height setting
2.Grasp hose grip and firmly push onto the base
3.Make sure Twist 'n Snap hose is snapped into position
4.Replace with new dust bag
5.Replace brush
6.Remove brush and clean debris from brush ends
7.Follow instructions for clearing clogs
8 0 0 . 2 3 7 . 7 6 9 1
1/22/07 2:04:33 PM