Bissell 3535 warranty How to use this guide, Assembly, Attach handle to vacuum

Page 5

How to use this guide

This User’s Guide has been designed to help you get the utmost satisfaction from your BISSELL PowerForce. You’ll find assembly and operating instructions, safety precautions, as well as maintenance and troubleshooting instructions. Please read this Guide thoroughly before assembling your vacuum cleaner.

Pay particular attention to the product diagram, assembly instructions, and part names. Locate and organize all parts before assembly. Following this User’s Guide will greatly enhance your ability to get the most performance from your BISSELL PowerForce for many years.

Assembly

The only tool you’ll need to assemble your vacuum cleaner is a screwdriver.

Attach handle to vacuum

WARNING:

Plastic film can be dangerous. To avoid danger of suffocation, keep away from babies and children.

1.

3.

1.Stand the vacuum upright and slide the base of the handle firmly into the grooves at the top of the vacuum body.

2. Check to be sure the handle is fitted to the

1.

vacuum body. If there is a gap in front, continue to push firmly until the handle is flush.

3.Insert one screw from the assembly packet into the existing hole in the back of the handle. Tighten securely with a screwdriver.

Attach vacuum hose and tools

Hose

Collar

2.

1.Position the hose collar on the back of the vacuum as shown.

2.Attach the hose collar with two screws from the assembly packet. Tighten securely with a screwdriver.

3.Line up the tabs on the base of the Twist ‘n Snap Hose with the corresponding tab notches on the hose collar as shown. Turn the Twist ‘n Snap Hose to the left to lock the hose into place.

4.Grasping the Quick Reach® Handle, slide the end of the hose wand onto the suction intake opening. Snap the hose into the hose clip.

NOTE: The powerfoot will not operate effectively unless the hose wand is firmly attached to the suction intake opening.

5.Place the crevice tool inside the extension wand and slide them into the storage clip as shown.

3.

4.

5.

6.

6.Snap the combination upholstery/dusting brush

tool into the storage clip as shown.

w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

5

ug603-5577_3525_107.indd 5

1/22/07 2:04:28 PM

Image 5
Contents Warranty PowerForceThank you for buying a Bissell PowerForce Or injury Important Safety InstructionsProduct view Assembly How to use this guideAttach handle to vacuum Attach vacuum hose and toolsHighest Setting For plush pile or Berber carpet Powerfoot height adjustmentOperation Handle positionBag change indicator select models Maintenance and carePower cord Brush Never reuse a dust bagCover Replace dust bagReplace light bulb select models 169Replace drive belt Clearing clog TroubleshootingPossible causes RemediesPossible causes Remedies Vacuum cleaner difficult to push Possible causes RemediesWarranty Bissell Consumer ServicesIf your Bissell product should require service PO Box