Bissell 3535 warranty Never reuse a dust bag, Brush, Cover, Replace dust bag

Maintenance and care

Replace dust bag

Never reuse a dust bag.

Use only BISSELL Style 7 Dust Bags in your BISSELL PowerForce.

Style 7 EnviroFresh® Micro Filtration Dust Bags (# 30861)

Style 7 Dust Bags (# 32120).

1. Unplug cleaner from electrical outlet. 2. Pull the bag door outward to open. Set bag door aside.

3. Grasp dust bag collar, and pull collar from connector tube. Discard used dust bag.

4. Grasp new dust bag collar and push firmly onto connector tube. Tuck in dust bag.

5. Replace bag door by placing tab on bottom of door into opening as shown. Press top of door to snap securely shut.

NOTE: Vacuum will not suction while the bag door is removed.

Cleaning pre-motor & post-motor filters

Use only BISSELL Replacement Filters in your BISSELL PowerForce.

1.Unplug cleaner from electrical outlet.

Pre-Motor Filter

Post-Motor Filter

2.	The pre-motor filter, located in the bottom of the bag
	compartment, protects the motor from dirt particles. If	WARNING:
	filter becomes dirty, lift out filter and clean.
3.	The post-motor filter assists in the filtration process to	Do not operate cleaner
	return clean air to the room. To remove this filter, open	with damp or wet filters or
	the door on the side of the cleaner. Grasp filter and pull	without all filters in place.
	it straight out.
4.	The filters may be hand washed in cold water with	WARNING:
	mild detergent, then air dried.
5.	Reposition filters when completely dry.	To reduce the risk of
		injury from moving
Check rotating floor brush and drive belt		parts, turn off vacuum
		cleaner and disconnect
You should check your vacuum cleaner’s rotating floor		Power Plug from
		electrical outlet.
brush and drive belt regularly for wear or damage. You
should also clean the brush and brush ends of string, hair, and carpet
fibers. These can wrap around the brush and hamper its ability to
effectively clean your carpet. Also remove any debris that has
accumulated under the brush cover.
1.	Unplug cleaner from electrical outlet.
2.	Place handle in low position and turn vacuum cleaner
	over so bottom side is up.
3.	Remove the four screws as shown with a Phillips head	Brush
	screwdriver. Lift the brush cover off.	Cover

4.Grasp rotating floor brush at both ends and lift.

8 w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1

ug603-5577_3525_107.indd 8

1/22/07 2:04:32 PM