Maintenance/Storage

Bissell 1620 Maintenance/Storage, Turn Power Switch OFF. Make sure to switch SmartMix Dial to

Page 12

		Cleaning Technique
		Connect the Tough Stain Tool to the Flex Hose.
1.
		Plug into a proper outlet and turn the Power Switch ON.
	2.

While pressing the trigger, slowly move the spraying tool back

3. and forth over the soiled surface. Release the trigger to suction soiled water.

Continue to clean soiled area, working in small sections, until

4. no more dirt can be removed.

Caution: Do not overwet.

When the cleaning job is complete, refer to the

5. Maintenance/Storage section below.

Turn Power Switch OFF. Make sure to switch SmartMix Dial to

1. WATER ONLY.

Unplug Power Cord from outlet and wrap cord around the

2. Quick Release Cord Wrap.

Quick Release Cord Wrap™

Remove and rinse tools in clean water. Dry and replace.

Coil Flex Hose through Flex Hose Storage Brackets.

Flex Hose Storage Bracket

Remove Tank-in-Tank. Dispose of dirty water. See The Basics

5. section, page 8.

CAUTION:

PowerLifter Plus uses water and must not be stored where there is a danger of freezing. Freezing will damage internal components and void the warranty.

Image 12

Contents

PowerLifter Plus Thanks for Buying a Bissell PowerLifter Plus Deep Cleaner Important Safety Instructions Release DirtLifter PowerBrush ReadyToolsHow to Use This Guide How To Assemble Your PowerLifter PlusWhat Comes With Your PowerLifter Plus Basics How Your PowerLifter Plus Works To Fill The Tank-in-Tank Depress the Handle Release pedal to tilt back For final cleanup When the cleaning job is complete, rinse out the Tank-in Refer to the Maintenance/Storage section on pages Fabrics and moreHow To Clean Carpets Choose the SmartMix setting to match the cleaning jobMachine Preparation PreTreatingNormal Cleaning Plug the PowerLifter Plus into a proper outlet and turnAfter cleaning, you may want to turn the SmartMix Dial to While pressing the Spray Trigger, make one slow forwardSet up the machine following instructions in The Basics Important Check Upholstery TagsSection, pages Maintenance/Storage Turn Power Switch OFF. Make sure to switch SmartMix Dial toCap Rotor Filter Facing upward see illustration Set the black brush arm aside see illustrationBrush aside Locate and remove the broken Pump Belt To Install The Replacement Pump & Brush Belts Arm into original position see illustrationAssembly is now complete Troubleshooting Turn power OFF remove and reseat tankTurn power OFF, clean out lint screen, follow on Possible CausesBissell Consumer Services Bissell Consumer ServicesReadjust angle apply more downward pressure M. 8 p.m. ET0400 22 oz. Bissell Tough Stain PreCleaner Part Numbers And DescriptionsPart Name 213-4032About Your Warranty If your Bissell product should require serviceUse the Customer Service tab Bissell Consumer Services

Bissell 1620 Maintenance/Storage, Turn Power Switch OFF. Make sure to switch SmartMix Dial to

Cleaning Technique